RotoZip SCSØ2 Spiral Saw Manual Del Usuario página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Step 5
Pull the bit out far enough to slip it over the edge
of the box so it is now against the outside of the
box.
Step 7
While moving slowly and continuously along
the top contour you will feel the bit come to the
next corner. Round the corner and apply light
down and inward pressure until the bottom
corner is reached.
Step 6
While keeping the bit in contact with the outside of
the box move the tool counter clockwise while
applying light inward and upward pressure until
you feel and hear it come to the corner. As you
round the corner apply light pressure left and
downward.
Step 8
Move the Zip
®
Bit right and upward maintaining
light continuous pressure toward the box.
-12-
Step 9
Round the right bottom corner and begin moving
the bit upward while applying light pressure left
toward the box until you meet initial upward cut.
Push the power switch to off.
These step-by-step instructions are generalized to
acquaint you with the Spiral Saw™ power tool
operation. After some practice, you may develop a
motion technique with which you are more
comfortable. However, you must always begin the
cut somewhat centrally, and MOVE THE Spiral
Saw™ power tool ONLY COUNTER-CLOCKWISE
WHEN USING THE OUTSIDE EDGE AS A GUIDE
to take advantage of the "hugging" action of the
rotating bit along the contours of the template.
Remember to use a smooth continuous motion.
Step 10
The completed box, executed quickly, neatly and
in a fraction of the time taken by other methods.
-13-

Publicidad

Tabla de contenido
loading

Tabla de contenido