Prior To FIrst Use; Assembling The Appliance; Operation; Cleaning - Silvercrest SFR 3.7 A2 Instrucciones De Uso

Prior to first use

Assembling the appliance

1) Remove all packaging materials from the
appliance.
2) Push the vacuum attachment
connecting piece
NOTE
► This appliance is supplied with non-charged
batteries. The batteries must be charged for
2.5 hours before the first use.
3) Charge the appliance (see Chapter "Charging
the appliance").
The appliance is now ready for use.

Operation

ATTENTION! DAMAGE TO PROPERTY!
► Do not use foaming, corrosive, aggressive,
abrasive or chemical cleaning agents.
These can damage the appliance.

Cleaning

1) Set the tip of the spray nozzle
(jet) or SPRAY (fine water mist).
2) Attach the spray nozzle
ment .
3) Place the positioning ring
put it onto the spray nozzle
into place.
4) Fill the spray bottle with water and, if desired,
with a cleaning agent suitable for window
cleaning .
5) Screw the spray nozzle
wiping attachment
6) Pull the microfibre attachment
retainer on the wiping attachment
secure it with the velcro fastener.
7) Spray the surface that you wish to clean.
8) Using the microfibre attachment,
the sprayed areas and loosen any stubborn
dirt.
■ 36 │ GB │ MT
onto the
.
to STREAM
to the wiping attach-
over the tube and
so that it clicks
with the fitted
onto the spray bottle
over the
and
wipe over

Vacuuming

1) Press the on/off switch
lights up red.
NOTE
► If the indicator light
use, this indicates that the appliance needs
to be charged (see chapter on "Charging the
appliance").
2) Move the blade of the vacuum attachment
slowly from top to bottom across the wet
surfaces. The moisture is removed and sucked
into the dirt container
NOTE
► Never drag the blade sideways across wet
surfaces. Doing so prevents the water from
being vacuumed up; instead, it runs off the
side of the blade.
3) After you have finished a section, always start
again at the top.
ATTENTION! DAMAGE TO PROPERTY!
► Only continue working until the MAX mark
on the dirt container
switch off the appliance and empty the dirt
container :
Remove the plug on the dirt container
Pour away the dirty water and reclose the dirt
container . You can then resume working.
4) Once the entire surface is dry, press the on/
off switch
The indicator light
5) If necessary, dry off any streaks or remaining
moisture on the surface with a dry cloth.
.

Charging the appliance

NOTE
► Ensure that the appliance is switched off
before starting to charge the batteries.
. The indicator light
flashes red during
.
is reached. Then
again to switch the appliance off.
goes out.
SFR 3.7 A2
.