Napa CARLYLE HRC14-STOOL Instrucciones De Ensamble

OPERATION MANUAL
HRC14-STOOL HRC14-STOOL
TOOLS NEEDED
#2 Phillips Screwdriver
10mm Wrench
ASSEMBLY INSTRUCTIONS
1. Cross the legs (part# 1 & 2) to make an "X" shape at the
top of the stool. Make sure to put the upper leg (part# 1)
above the lower leg (part# 2).
2. Position the ring (part# 4) outside the legs. Assemble
the ring to the legs using four (4) bolts (part# 6) and four
(4) locknuts (part# 7). Tighten with screwdriver and
wrench.
3. Twist swivel plate (part# 9 ) until top and bottom plates are
offset. Set swivel plate (part# 9) on top of leg assembly.
Feed four (4) bolts (part#8 ) through swivel plate (part# 9)
and leg assembly. Fasten with locknuts(part#7).
4. Place the seat (part# 5) design side down on the ground.
Turn leg assembly upside down so the bottom is in the air
and place on top of seat.
5. Line holes in swivel plate with the makers in seat and
screw leg assembly to seat using four (4) screws
(part#10 ). Securely tightened with a screwdriver.
6. Stand completed product on its legs.
WARNING
Read and follow all instructions in User's Manual. • User
and bystanders must wear eye protection that meets ANSI
Z87.1 and OSHA standards. • Do not allow children to
climb on product as it could topple causing personal injury.
• Do not stand on product as it could result in a fall caus-
ing personal injury. • Do not exceed weight capacity of 250
lbs. • This product contains chemicals known to the State
of California to cause cancer and birth defects or other re-
productive harm. Wash hands thoroughly after handling.
• Failure to heed these warnings may result in personal
injury and/or property damage.
HRC14-STOOL
REPLACEMENT PARTS AVAILABLE
RSBSBK Bolt Kit
RSBS2 Swivel
RSBSFT Feet (Four Piece Set)
Product meets California 93120 compliance for formaldehyde.
1
Carlyle Barstool
BOLT KIT
4 - M6 x 31mm Bolt
8 - M6 Nylon Locknut
4 - M6 x 45mm Bolt
4 - M6 x 12mm Screw
5
10
9
8
rev. 08/05/14
1
2
6
7
4
3