heat4all ICONIC Instructions De Montage página 2

Heat4All ICONIC Infrared Heating
Mounting Manual (Towel Rails)
The Towel Rails kit includes:
16 screws M3 x 10 (Torx TX10)
4 screws 2.9 x 9.5 (Torx TX10)
Step 1:
Please make sure all parts are included in the mounting kit. We are not liable for any
damages resulting from the mounting of the towel rails. Any damages resulting from
mounting the rails not using our original parts do not fall under our warranty and we will
not be liable for any consequential damages.
The towel rails need to be installed before mounting the panel on the wall. The mounting
rails may be installed on the upper or lower part of the panel. The rods have to be
mounted parallel to the short side of the panel.
Step 2:
To install the towel rails on one of our Heat4All
ICONIC Classic Panels, please remove either the 4
upper or the 4 lower screws on its rear, depending
on where you would like to position the rails. To
do so, please use a Torx TX10 screwdriver.
There are no screws on the rear of our Picture,
Glass Picture or Decor Glass Panels; instead there
are stickers covering the mounting holes sealing
the panel. These need to be pierced in the next
step.
2 mounting rails
2 rail parts short
2 rail parts long
2 rods
Step 3:
Put the two mounting rails on the rear of the panel (see
pictures) so that the mounting holes are visible.
The mounting rails are to positioned so that the 4 holes
for the screws are above the 4 mounting holes. When
installing the rails on one of our Heat4All ICONIC Classic
Panels, please use 4 screws M3 x 10 (Torx TX10) to
fasten the mounting rails.
For intalling the towel rails on any other panel, please
use the 4 screws 2.9 x 9.5 (Torx TX10). In this case
please pierce the stickers covering the mounting holes
with the tip of the screws.
Step 4:
Screw the short rail parts as well as the long rail parts in
pairs onto the mounting rails (outer row of holes with
screw thread).
To do so, please use 8 screws M3 x 10 (Torx TX10).
The exact position of the two rails can be freely adjusted
in 5 cm increments.
Step 5:
Put the two rods into the rails and fasten them using 4
screws M3 x 10 (Torx TX10).
The Towel Rails are now installed and you can mount
the panel on the wall. To do so, please refer to the
Mounting Manual (Panel).