Assembly Of Handheld Remote Control - Ellington REGATTO REG54BNK3 Guia De Instalacion

9. Light Kit Assembly. (cont.)
Install one 75 watt halogen bulb, type JD E11 (included).
Tip: Do not touch glass portion of bulb with fingers or
hands. Oil from skin can cause bulb to overheat and go out
prematurely. Use cardboard box or foam wrapping bulb
was packed with to layer around glass portion of bulb.
Locate metal brackets in one of the hardware packs.
Raise glass shade to light kit fitter and push glass shade
gently into light kit fitter. Firmly slide metal bracket over
outer edge of light kit fitter, aligning hole in metal
bracket with hole in light kit fitter. Partially insert screw
that was previously removed. Repeat for remaining
metal brackets. Tighten all 3 screws to secure glass
shade. Do NOT overtighten screws as glass may crack
or break.
IMPORTANT: When you need to replace the bulb,
please allow bulb and glass shade to cool down before
touching. Keep in mind not to touch the bulb itself as
described above (see "Tip").

10. Assembly of Handheld Remote Control.

IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10 for
remote control assembly instructions. If you have
already installed the wall control but do not wish
to use the handheld remote control, please proceed
to Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was
not previously used)--use wire cutters to cut off
each wire as close to the wall control as possible.
[Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
The dimmer switch (labeled DIM and ON) has
been pre-set to the "ON" position (DIM). If you do
not wish to have dimming capability, please
move the switch to the "OFF" position (ON).
[Refer to diagram 2.]
motor housing
metal
bracket
diagram 1
diagram 2
page 8
bulb
glass shade
remote
control
cover
(top)
(bottom)
wall control
dimmer
wire
switch
- 1 1
DIM ON
wire
12V battery
light kit fitter
metal
bracket
wire