KitchenAid KFIS25XVMS Instrucciones Para El Usuario página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Temperature Controls
For your convenience, your temperature controls are preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended set points.
Press the touch pad next to "FRESH FOOD TEMP" on the
main menu to display the current set point of the
compartment. Press the touch pad next to "WARMER" or
"COLDER" to adjust the set point to the recommended 38°F.
Press the touch pad next to "Done" to lock in the setting.
Press the touch pad next to "FREEZER TEMP" on the main
menu to display the current set point of the compartment.
Press the touch pad next to "WARMER" or "COLDER" to
adjust the set point to the recommended 0°F. Press the touch
pad next to "Done" to lock in the setting.
To Turn Cooling Off/On:
Cooling Off controls all cooling functions, the control panel and
the dispenser. It does not disconnect power to the refrigerator.
Press and hold the Cooling Off touch pad for three seconds.
The LED will light up to indicate that cooling is Off. Neither
compartment will cool.
Press the Cooling Off touch pad again to turn on the cooling.
The LED will turn off.
Adjusting Controls
The FRESH FOOD TEMP control adjusts the refrigerator
compartment temperature. The FREEZER TEMP control adjusts
the freezer compartment temperature.
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart as a
guide.
To Adjust Set Point Temperatures:
The display will show the set point for approximately 3 seconds.
Press the touch pad next to "WARMER" or "COLDER" to
adjust the set point to the desired temperature. Then, press
the touch pad next to "Done" to lock in the new set point
temperature.
NOTE: Except when first turning on the refrigerator, do not adjust
either temperature control more than one setting at a time. Wait
24 hours for the temperature to stabilize between adjustments.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too little ice
REFRIGERATOR too cold
FREEZER too cold
ADJUSTMENT:
FRESH FOOD Control
1° lower
FREEZER Control
1° lower
FRESH FOOD Control
1° higher
FREEZER Control
1° higher
Options
Door Alarm
The Door Alarm feature sounds an audible alarm every few
seconds when the either refrigerator door has been left open for
3 continuous minutes. The alarm will sound until the door is
closed or Door Alarm is turned off.
1. On the main menu, press the touch pad next to "Options."
2. Press the touch pad next to "Door Alarm Is On" to switch
between ON and OFF. Press the touch pad next to "Done" to
lock in the desired setting and return to the main menu.
Humidity Control (on some models)
The humidity control feature turns on a heater to help reduce
moisture on the door hinge seal. Use in humid environments or
when you notice moisture on the door hinge seal. The refrigerator
uses more energy when Humidity Control is on.
1. On the main menu, press the touch pad next to "Options."
2. Press the touch pad next to "Humid Ctrl Is On" to switch
between ON and OFF. Press the touch pad next to "Done" to
lock in the desired setting and return to the main menu.
Vacation Mode
The vacation mode feature decreases the number of automatic
defrost cycles. Once set, vacation mode will remain on until a
door is opened or the feature is turned off on the control panel.
NOTE: Door openings are ignored for the first hour after Vacation
mode is activated.
1. On the main menu, press the touch pad next to "Options."
2. In each of the following screens, continue to press the touch
pad next to "More Options" until "Vac. Mode is Off" appears
on the display.
3. Press the touch pad next to "Vac. Mode is Off" to switch
between ON and OFF. Press the touch pad next to "Done" to
lock in the desired setting and return to the main menu.
Max Cool
The Max Cool feature assists with periods of high refrigerator or
freezer use, full grocery loads, or temporarily warm room
temperatures by lowering the freezer and refrigerator to the
minimum temperatures.
1. On the main menu, press the touch pad next to "Options."
2. In each of the following screens, continue to press the touch
pad next to "More Options" until "Max Cool is Off" appears on
the display.
3. Press the touch pad next to "Max Cool is Off" to switch
between ON and OFF. Press the touch pad next to "Done" to
lock in the desired setting and return to the main menu.
NOTE: The Max Cool feature will automatically shut off in
approximately 2 hours.
Sabbath Mode
The Sabbath mode feature turns off all lights, disables the water
and ice dispenser, disables all alarms and tones, disables the
automatic defrost feature and disables the control panel.
While the refrigerator is operating in Sabbath mode, any touch of
the control panel will display the Sabbath mode control which will
allow you to turn off the Sabbath mode feature.
Turn Sabbath mode on:
1. On the main menu, press the touch pad next to "Options."
2. In each of the following screens, continue to press the touch
pad next to "More Options" until "Sabbath Is Off" appears on
the display.
3. Press the touch pad next to "Sabbath Is Off" to switch
between ON and OFF. Press the touch pad next to "Done" to
lock in the desired setting and return to the main menu.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido