Gewiss Chorus NAXOS COMBI GW10962WH Manual Para El Instalador página 3

WARNINGS
The information in this manual is subject to change without advance notice.
The manufacturer shall not be held liable for any errors which this document may contain.
ATTENTION
• After removing the packaging, check the condition of the unit.
• The packaging items (plastic bags, expanded polystyrene, etc.) must not be handled by children as they may be dangerous.
• Carefully read the instructions before starting installation. Perform work as specified by the manufacturer.
• Before connecting the equipment, make sure that the rating plate data corresponds to that of the distribution network.
• An omnipolar switch, with contacts separated by at least 3mm, must be installed upstream on the equipment, on the electric system of
the building.
• The manufacturer declines all liability for any damage as a result of improper, incorrect or unreasonable use.
• Before performing any cleaning or maintenance operation, disconnect the equipment from the power supply network by opening the
system switch.
• In case of failure and/or malfunction of the device, detach it from the power supply and do not tamper with it.
• Use original spare parts.
• Installation, programming, commissioning and maintenance of the product must only be performed by qualified technicians who have
been properly trained in compliance with current standards including compliance with accident prevention.
• Operate in sufficiently lighted areas that are conducive to health and use tools, utensils and equipment that are in good working order.
• Upon completion of installation, always check for correct operation of the unit and the system as a whole.
• Do not install the device outdoors or in areas where it is exposed to seepage or splashes of water.
• Handle the device with care. It contains electronic parts that are fragile and sensitive to humidity.
• The electronic cards can be seriously damaged by discharges of static electricity. If they are to be handled, wear suitable clothing and
anti-static footwear, or at least, ensure static electricity has been discharged by touching with the fingertip a metallic surface connected
to the earth system (e.g. the chassis of a household appliance).
• Weld the joints between wires to prevent false alarms caused by oxidation of the wires.
• The electrical system must comply with current standards in the country of installation.
• Failure to comply with the above instructions may compromise the unit's safety.
• The installer must make sure that the information for the user, where applicable, is present on the devices.
• Dispose of the unit in accordance with current standards.
3
NAXOS
IT
EN