Numark Party Mix Live Guia Del Usuario página 4

12. Platter/Jog Wheel: This capacitive, touch-sensitive jog wheel controls the audio when
the wheel is touched and moved. You can also grab the non-touch-sensitive outer wheel
to bend the pitch of the track.
13. Pitch Fader: This controls the speed of the music. Moving towards the "+" will speed the
music up, while moving towards the "–" will slow it down.
14. Sync: Press this button to automatically match the corresponding Deck's tempo with the
opposite Deck's tempo and phase.
15. Cue: When the Deck is paused, you can set a Temporary Cue Point by moving the
Platter to place the playhead at the desired location and then pressing the Cue button.
During playback, you can press the Cue button to return the track to this Temporary Cue
Point. (If you did not set a Temporary Cue Point, then it will return to the beginning of the
track.)
16. Play/Pause: Starts and suspends playback.
17. Performance Pads: These pads can be used to trigger Hot Cues, Loops and Samples,
and to apply effects. To change the function of the pads, press the Pad Mode button.
18. Pad Mode: Press this button to change the current function of the Performance Pads.
• Cue: Each pad assigns at Hot Cue Point, or returns the track to that Hot Cue Point.
When a pad is unlit, you can assign a Hot Cue Point by pressing it at the desired
point in your track.
• Loop: Each pad triggers and auto-loop of a different length.
• Sampler: Each pad triggers a sample in Serato DJ Lite.
• Effects: Pads 1–3 on each deck trigger an effect. Pad 4 on each deck cycles
through time divisions for beat-based effects, from 1/16 to 8 beats.
19. Pad Mode Indicator: These LEDs indicate the current setting of the Performance Pads.
20. Speakers: When the Speaker On/Off switch on the left side panel is set to On, these
speakers will play the current audio. Use the Main Gain knob on the top panel to control
the volume of the speakers.
Left Side Panel
1. USB: This USB connection sends and receives audio and
control information from a connected computer.
2. Main Output (1/8" / 3.5 mm): Use standard 1/8" / 3.5
mm cables to connect this output to speakers or an
amplifier system.
3. Headphone Output: Connect headphones to this 1/8"
(3.5 mm) jack for monitoring the signal. The headphone
volume is controlled using the Cue Gain knob.
4. Speaker On/Off: Use this switch to turn the Party Mix
Live internal speakers on or off.
4
1 2
3 4