–
Setting the volume
During a call, repeatedly press the "+" or "–" button on the BT Drive
Free 111.
–
Mute on/off
To mute the microphone, press the MODE button. The red LED starts
fl ashing.
To switch the microphone on again, press the MODE button again.
–
Call transfer
From BT Drive Free 111 to cell phone: During a phone call, press the volume
buttons +/– at the same time to transfer the call to the cell phone.
From cell phone to BT Drive Free 111: Press the MFB button and the call
is transferred.
Resetting the BT Drive Free 111
To reset the device to factory settings, proceed as follows:
–
The BT Drive Free 111 must be in standby mode.
–
Press the volume buttons +/– at the same time for approx. 10 seconds
until the LED alternately fl ashes red and blue.
–
Press the two volume buttons again at the same time for approx. 2 seconds
until two short sounds are emitted and the LED stops fl ashing. The BT Drive
Free 111 switches off and the factory settings are restored.
–
After resetting the device and switching it on again, the red LED fl ashes
every 3 seconds and 3 sounds are emitted every minute. This is normal
and ends again with the next pairing.
18
LED indicators
Device status
Red LED
OFF mode
Off
Switching on
Switch-off
On for 3 sec.
Standby before
Flashes every
pairing
3 sec.
Standby after
pairing
Standby –
Flashes every
battery nearly
3 sec.
depleted
During a call
During pairing
Flashes alternately
Pairing
terminated
Mute
Constantly on
While charging
Constantly on
Charging
Off
complete
Declaration of conformity
The Blaupunkt AudioVision GmbH & Co. KG declares that this product complies
with the basic requirements and the other relevant regulations of the direc-
tive 1999/5/EC. The declaration of conformity can be found on the Internet
under www.blaupunkt.com.
Blue LED
Sounds
Off
On for 3 sec.
Short sound
Long sound
3 sounds every
minute
Flashes every
3 sec.
3 sounds every
minute
Flashes every
15 sec.
Flashes every
Long sound
3 sec.
Off
19