Briggs & Stratton Brute 074003 Manual Del Operario página 6

ASSEMBLY
Install the Wheel Kit as Follows (Figure 4):
Figure 4 - Install Wheel Kit
1. Slide M10-1.5x75 bolt through center of wheel.
2. Slide a M10 flat washer over bolt.
3. Place threaded end of bolt through wheel bracket on
base of air tank.
NOTE: Be sure to install wheel with raised hub inboard.
4. Place a M10 flat washer and M10 lock washer on
threaded end of bolt inside wheel bracket.
5. Using a 17mm wrench and socket wrench, place M10 hex
nut on threaded end of bolt and tighten.
IMPORTANT: DO NOT overtighten the nut.The wheel
must be able to rotate freely.
6. Repeat steps 1 through 5 to install the second wheel.
7. Return compressor to normal operating position (resting
on wheels and rubber foot pads).
Add Oil and Install Pump Oil Breather
Cap
1. Ensure compressor is resting on a flat, level surface.
2. Open Drain Valve (rotate fully counterclockwise) to
release residual air pressure build-up in air tank
(see Figure 5).
Figure 5 - Drain Valve in CLOSED Position
Drain Valve shown
in CLOSED
position
6
WARNING
Residual compressed air in pump can propel oil
and cause soft tissue damage to exposed skin or
eyes leading to severe injury.
• Always wear ANSI Z87.1 approved safety glasses with side
shields.
3. Remove and discard shipping cap.
4. Using oil funnel, slowly add provided oil.Visually inspect
oil level frequently at sight glass to avoid overfilling air
compressor pump (see Figure 6).
Figure 6 - Add Oil and Install Pump Oil Breather Cap
NOTICE
Serious damage may result if operating the unit with
insufficient oil. Inspect oil level daily or with each use.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Install pump oil breather cap into the oil fill (see Figure 6).
6. Wipe up any spilled oil.
7. Close Drain Valve (rotate fully clockwise) (see Figure 5
earlier).
Oil Breather Cap
Oil Fill
Location
MAXIMUM
Oil Level
PROPER
Oil Drain Plug Oil Level