Connecting Electricity - GEA Hotpoint HCM4SMWW Manual De Utilizacion Y Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
WARNING
EXPLOSION HAZARD
explosion, or death.
WARNING
Plug into a grounded 3-prong outlet.
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For
personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong (grounding) wall outlet to minimize the
possibility of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly
grounded.
Where a standard 2-prong wall outlet is encountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
The freezer should always be plugged into its own
individual electrical outlet which has a voltage rating
that matches the rating plate.
PROPER DISPOSAL OF YOUR OLD APPLIANCE
WARNING
SUFFOCATION AND ENTRAPMENT HAZARD
IMPORTANT: Child entrapment and suffocation are not
problems of the past. Junked or abandoned appliances
please follow the instructions below to help prevent
accidents.
Refrigerant and Foam Disposal:
material used require special disposal procedures. Contact your local authorities for the environmentally safe
disposal of your appliance.
READ AND SAVE THESE INSTRUCTIONS
49-60816-1
INSTALLATION

CONNECTING ELECTRICITY

ELECTRICAL SHOCK HAZARD
A 115 Volt AC, 60 Hz, 15- or 20-amp fused, grounded
electrical supply is required. This provides the best
performance and also prevents overloading house
wiring circuits which could cause a fire hazard from
overheated wires.
Never unplug your freezer by pulling on the power
cord. Always grip plug firmly and pull straight out from
the outlet.
Immediately discontinue use of a damaged supply
cord. If the supply cord is damaged, it must be
replaced by a qualified service professional with an
authorized service part from the manufacturer.
When moving the freezer away from the wall, be
careful not to roll over or damage the power cord.
Before You Throw Away Your Old Freezer:
Take off the freezer lid.
Leave the baskets in place so that children may not
easily climb inside.
3

Publicidad

Tabla de contenido
loading

Tabla de contenido