Publicidad
Idiomas disponibles
Idiomas disponibles
Note! The sticky strip may lead to discolouration or leave glue residues on certain
surfaces.
4.2 LOCATING THE IR EXTENDER LED
2
Place the LEDs (2) from the IR extender cable precisely on the IR window (infrared
sensor) on the A/V equipment that you wish to operate.
•
Ensure that the IR extender cable's LEDs are stuck precisely on the A/V device's
infrared sensor (this can be extremely accurate on some devices). The exact position
can easily be located by shining a torch on the front panel and looking for the IR
sensor window.
•
All IR LEDs include self-adhesive film with which they are attached to your A/V
equipment.
•
Test the position and the performance of the IR LEDs before you secure them to the
IR window on your A/V equipment.
•
If you use just one or two of the three LEDs, you can leave the other IR LED unused.
Never remove it from the extender cable!
4.3 LOCATING THE IR MODULE
3
V
Mount the IR Module (3) at an accessible place behind or alongside your A/V
equipment, in the vicinity of an electrical socket.
•
Be aware of the cable length of the IR LEDs and the IR receiver.
•
Make sure that the connections remain accessible and that the 'IR data' light
remains visible so you can check it is working properly.
•
Use the self-adhesive strip which is supplied to locate the IR receiver just about
anywhere you please.
INVISIBLE CONTROL6
TM
Publicidad
