Operating The Transmitter - Marmitek SURROUND ANYWHERE 220 Manual Del Usario

5. Operating the transmitter

After powering up the transmitter, the transmit light will go on for
approximately five seconds while the transmitter initializes.
After initialization, the transmit light will go out.
Initially, set the transmitter volume control to a middle setting.
Once audio is detected at the audio input, the transmit light will go
on and the transmitter will transmit the audio signal.
When audio is no longer detected, the transmitter will go into
standby mode after approximately 30 minutes. The Signal indication
LED will go out. During standby mode, no signal is transmitted.
Transmit light
TRANSMITTER
Transmitter volume control
SPEAKER LEVEL INPUT PRE-AMP INPUTS DC 9V
L R
-
+
L R
SURROUND ANYWHERE 220 7