T-Fal KM740 Guia Del Usuario página 14

TF_COFFEEMAKER_KM740_NC00115301_NAFTA_EXE 12/09/12 11:26 Page12
PROBLEM
The coffee has a bad
taste.
You can not close the
top lid of the coffee
maker properly
Coffee drips on the
heating plate, when
removing the carafe
On each use, the
clock starts at 0:00
You can not enter the
desired settings for
automatic program-
ming
You can not pre select
the reduced tempera-
ture of the warming
plate for automatic
operation
The automatic func-
tion did not start at
the selected time
The coffee does not
drip in the carafe
The coffee is too cold
If your appliance still does not work properly, please call your respective
country's Consumer Service.
12
SOLUTION
• The coffee dispenser needs to be cleaned.
• The coffee grounds are no suited to your coffee dispenser.
• The proportion of coffee to water is inadequate. Adjust it to
suit your taste.
• The quality and freshness of the coffee are not optimal.
• Poor-quality water. Use filtered or bottled water.
• Check to ensure the filter holder is inserted correctly.
• The filter holder is too large : only use a paper filter of the
suitable size.
• Place the carafe back on the heating plate, the pause & serve
mechanism is blocked. Wait until the filter holder is
completely empty.
• Clean the filter holder.
• Set the clock (section 4. Setting the clock) The setting of the
clock will be deleted when the appliance is unplugged or after
a power failure.
• Set the clock (section 4. Setting the clock).
• The appliance is switched off during programming : you can
only program the temperature of the warming plate if the
appliance is in operation (red light on ON/OFF button and
orange light on the keep warm
• Adjust the clock. Pay attention to the AM and PM indicators.
• Check the setting of the clock.
• Check start time as well as AM and PM indicators.
• Check to make sure the water tank is filled.
• The appliance is switched off .
• Press the keep warm
temperature (the heating plate temperature is reduced and
the orange light of the keep warm
button).
button to switch back to normal
button will blink.