EDM Product 08702 Manual De Instrucciones página 12

ASSEMBLY
Warning!
Prior to assembly and adjustment always unplug the tool.
Installing the Grinding Wheel
1. Depress and hold down the spindle lock. To prevent
damage to spindle or spindle lock, always allow motor to
come to a complete stop before engaging spindle lock.
2. Remove the outer flange with spanner turning in
anti-clockwise direction. Do not remove the inner flange.
3. Make sure the slot on the inner flange is engaged with the
square neck of the spindle.
4. Place the grinding wheel over the spindle with the
depressed center against the inner flange.
5. Depress and hold down the spindle lock again, mount the
outer flange and securely tighten it with spanner provided
clockwise.Do not overtighten it.
Mounting the Auxiliary Handle
The tool has three screwed holes on top, left and right side of
EN INSTRUCTION MANUAL
ANGLE GRINDER
the gear housing. Operators can choose any one of them to
mount the auxiliary handle depending on specific working
condition and their own habit.
Adjusting the Wheel Guard
This tool comes with a wheel guard. The guard must be fitted
before using the tool.
1. Loosen the bolt on the collar of wheel guard with hex key.
2. Align the protruding part inside the circular collar with the
notch on the front cap. Mount the collar fully onto the front
cap.
3. Turn the wheel guard to a desired angle after the collar is
fully inserted. Retighten the bolt to secure the wheel guard.
OPERATION
This angle grinder is designed for the following purposes:
1. Removal of casting burrs and finishing on various types of
steel, bronze, aluminum materials and castings.
2. Beveling and finishing weld seams
3. Grinding of welded sections cut by means of welding.
4. Grinding of synthetic resin bricks, marbles etc.
REF. 08702