AVE CRONOTC1B Instrucciones Para El Uso página 36

3. Use the ▲ and ▼ buttons to modify the temperature level (T1, T2 or T3).
4.
5.
6. To directly duplicate the temperature profile by going to the next day, press
COPY (to customize every single day separately, refer to step 5 below).
7. Press ENTER to go to the next day, then repeat the operations described
starting from step 2 for the other days of the week (the "Holiday" profile will
be indicated as DAY 8). To go back to the programming menu main page, use
the ENTER button to scroll through the eight days or keep the ENTER button
pressed for 3 seconds.
If no button is pressed within the next three minutes, the chronothermostat
operating mode previously used will be resumed.
ENGLISH
Reset default parameters
To resume the preset temperature profiles and values (T1-T2-T3-Temperature
used with the Manual mode, Temperature used with the Jolly mode, Antifreeze
temperature, OFF function), keep the ▲ and ▼ buttons pressed simultaneously
when you are in the temperature profile programming mode.
Displaying the temperature detected by the separate probe
To display the temperature detected by the external floor temperature probe the
chronothermostat must be configured (refer to «chronothermostat configuration»
pag. 41) and the probe must be connected.
To display the temperature value read by the external probe, press the button of
the operating mode currently used (the temperature will blink).
To display again the temperature detected by the chronothermostat, press again
the button of the operating mode currently used (the temperature will not blink
any longer).
36