Specific Safety Rules; Electrical Safety; Personal Safety - Norton TC-405 El Manual Del Propietario

SPECIFIC SAFETY RULES:

1. DANGER! Keep hands away from cutting area and blade. If both hands are holding the saw, they cannot be cut
by the blade.
Keep your body positioned to either side of the saw blade, but not in line with the saw blade. KICKBACK could cause
the saw to jump backwards.
Do not reach underneath the work. The guard can not protect you from the blade below the work.
General Safety and Rules
WARNING: Read and understand all instructions.
electrical shock, fire and/or serious personal injury.
Work Area
Keep your work area clean and well lit.
Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or
dust. Power tools create sparks which may ignite the dust or fumes.
Keep bystanders, children, and visitors away while operating a power tool.
control.

Electrical Safety

Double insulated tools are equipped with a polarized (one blade is wider than the other.) This plug will fit in a
polarized outlet only one way. If the plug does not fully fit in the outlet, reverse the plug. If it still does not fit,
contact a qualified technician to install a polarized outlet. Do not change the plug in any way.
eliminates the need for the three wire ground power cord and ground power supply system.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators.
increased risk of electrical shock if your body is grounded.
Don't expose power tools to rain or wet conditions.
shock.
Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an outlet. Keep cord away
from heat, oil, sharp edges, or moving parts. Replace damaged cords immediately.
risk of electric shock.
When operating a power tool outside, use an outdoor extension cord marked "W-A" or "W".
for outdoor use and reduce the risk of electric shock.

Personal Safety

Stay alert, carefully watch what you are doing and use common sense when operating a power tool. Do not use
tool while tired or under the influence of drugs, alcohol or medication.
tools may result in serious personal injury.
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves
away from moving parts.
Avoid accidental starting. Be sure switch is off before plugging in.
plugging in tools that have the switch are extremely dangerous and prone to accidents.
Cluttered benches and dark areas are prone to accidents.
Loose clothing, jewelry, or long hair can be caught in moving parts.
Failure to follow all instructions listed below, may result in
Water entering a power tool will increase the risk of electrical
The lack of attention while operating power
Carrying tools with your finger on the switch or
Distractions can cause you to loose
Double insulation
There is an
Damaged cords increase the
These cords are rated