Troubleshooting; Repair And Maintenance - VWR VisiScope 200 Serie Manual De Instrucciones

Ocultar thumbs Ver también para VisiScope 200 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 50

Troubleshooting

Review the information in the table below to troubleshoot operating problems.
PROBLEM
LIGHT DOESN'T TURN ON
IMAGE CANNOT BE SEEN OR
IS DARK.
IMAGE IS UNCLEAR, BLURRED
OR HAS INSUFFICIENT
CONTRAST.

Repair and maintenance

Microscopy environment
This microscope is recommended for use in a clean, dry and shock free environment with a temperature of
0-40°C and a maximum relative humidity of 85 % (non condensing). Use a dehumidifier if needed.
After using the microscope
The microscope should always be kept vertical when moving it so that no moving parts, such as the
eyepieces, fall out.
Never mishandle or impose unnecessary force on the microscope.
Never attempt to service the microscope yourself.
After use, turn down the illumination intensity control and turn the light off. Cover the microscope with included
the dust cover, and keep it in a dry and clean place.
Electrical safety precautions
Before plugging in the power supply, make sure that the supplying voltage of your region matches with the
operation voltage of the equipment and that the lamp switch is in off-position.
Users should observe all safety regulations of the region. The equipment has acquired the CE safety label.
However, users do have full responsibility to use this equipment safely.
Cleaning the optics
If the optical parts require cleaning first use compressed air.
If that is not sufficient use a soft lint-free cloth with water and a mild detergent.
And as a final option use the piece of cloth moistened with a 3:7 mixture of ethanol and ether.
Note: ethanol and ether are highly flammable liquids. Do not use them near a heat source, near sparks or
near electric equipment. Use these chemicals in a well ventilated room.
Remember to never wipe the surface of any optical items with your hands. Fingerprints can damage the op-
tics. Do not disassemble objectives or eyepieces in an attempt to clean them.
CAUSE
Power supply not connected Check that the power supply cable is
Connected
Brightness level is low
Zoom is too high
Objectives or filters are dirty
Focus is wrong
Dioptric compensation is not
correct
9
SOLUTION
well inserted on the rear of the micro-
scope
Rotate the brightness adjustment
control and check if there is an
increase in the light output
Rotate the brightness adjustment
control
Set the lowest zoom magnification in
order to have a brighter image
Wipe them clean
Rotate the focus knobs until you obtain
a sharp image
Adjust the rings under the eyepieces
in order to obtain the same focussed
image with both eyes

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Stb250Szb250Szt250630-1577630-2725630-1576

Tabla de contenido