Publicidad
Idiomas disponibles
Idiomas disponibles
when barefoot or wearing
open sandals. Avoid wearing
clothing that is loose fitting or
that has hanging cords or ties.
b) Do not wear loose clothing or
jewellery that can be drawn
into the air inlet. Keep long hair
away from the air inlets.
c) Obtain ear protection and
safety glasses. Wear them at
all times while operating the
machine.
d) Operate the machine in a
recommended position and
only on a firm, level surface.
e) Do not operate the machine
on a paved or gravel surface
where ejected material could
cause injury.
f) Before using, always visually
inspect to see, that the
8
fasteners are secure, the
housing is undamaged and
that guards and screens are
in place. Replace worn or
damaged components in sets
to preserve balance. Replace
damaged or unreadable labels.
3) OPERATION
a) Before starting the machine,
make certain that the feeding
chamber is empty.
b) Keep your face and body away
from the feed intake opening.
c) Do not allow hands or any
other part of the body or
clothing inside the feeding
chamber, discharge chute, or
near any moving part.
d) Keep proper balance and
footing at all times. Do not
Cordless Li-Ion Blower
overreach. Never stand at a
higher level than the base of
the machine when feeding
material into it.
e) Always stand clear of the
discharge zone when operating
this machine.
f) If the machine should start
making any unusual noise or
vibration, immediately shut off
the power source and allow the
machine to stop. Remove the
battery pack from the machine
and take the following steps
before restarting and operating
the machine:
i) Inspect for damage;
ii) Replace or repair any damaged
parts;
iii) Check for and tighten any loose
parts.
g) Do not allow processed
material to build up in the
discharge zone; this may
prevent proper discharge
and can result in kickback of
material through the intake
opening.
h) If the machine becomes
clogged, shut-off the power
source and remove the battery
pack from the machine before
cleaning debris.
i) Never operate the machine
with defective guards or
shields, or without safety
devices.
j) Keep the power source clean of
debris and other accumulations
to prevent damage to the
power source or possible fire.
k) Do not transport this machine
EN
Publicidad
