Technical Specifications - Velleman EX410 Manual Del Usario

6. Installation
Refer to the illustrations on page 2 of this manual.
• Choose the location for the camera, keeping following guidelines in mind:
o do not install the camera in locations where extremely high or low temperatures or excessive
vibrations may occur.
o avoid mounting the camera near high electro-magnetic fields.
o do not aim the camera at the sun or other extremely bright objects or reflections (e.g. metal doors).
o The connection cables run at the inside of the mounting bracket, and leave at the backside [3]
(default). They can be re-guided to leave via the top [4] or bottom [5] of the mounting bracket.
• When the connection cables need to go through the wall, a hole of at least Ø20mm (max. Ø35mm)
must be foreseen at the mounting location.
• Guide the cables though the cable hole when applicable. Mount the mounting bracket on the wall using
4 screws (included). Note that the camera must be resting on top of the mounting bracket.
• Release hex screws [6] and [7] (hex key included) and point the camera to the desired field of
observation. Tighten hex screw [7] to secure the horizontal position and hex screw [6] for the vertical
position.
• Connect the video connector [1] to a monitor (not incl.).
• Connect the power connector [2] to a 12VDC power supply (not incl.).
• Manually adjust the zoom with screw [F] and the focus with screw [G]. These screws are located at
the back of the camera under protective caps. After adjusting, replace the protective caps.
• The sunshield can be mounted or dismounted by sliding the sunshield towards the front of the camera.

7. Technical specifications

IP rating
scanning system
pick-up element
image size
number of pixels
resolution
min. illumination
max. IR projection distance
interlace
video output level
video S/N ratio
white balance
AEI
gamma
built-in lens
type
focal length
lens angle
humidity
power supply
power consumption
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced to
any electronic medium or otherwise without the prior written consent of the copyright holder.
04/01/2010
CAMCOLBUL16N
IP66
PAL
Sony CCD sensor
1/3"
500(H) x 582(V)
420 TV lines
0.8 lux (IR off) / 0 lux (IR on)
± 70m
2:1
1.0Vpp, 75 ohms, composite
> 48dB (AGC off)
automatic
1/50 ~ 1/100 000s
>= 0.45
manual varifocal lens
4.0 ~ 9.0mm
37° ~ 76°
< 90° RH
12V DC 450mA (not incl., e.g. PS1205R)
5.5 W (IR leds on) / 1.5W (IR leds off)
Ø95 x 160mm
1.15kg
4 ©Velleman nv