Configuring The Wi-Fi Parameters - SOMFY Visidom ICM100 Manual De Instalación

ICM100
c W
onfiguring the
To complete the installation of your camera for use with the Wi-Fi:
a. Click the
b. Select the "Advanced" button to open the advanced configuration menu and enter the default
administrator password 123456.
c. In the "Wi-Fi parameters" section, select your Wi-Fi network and enter the passphrase for your
hub. (Fig. 10)
The camera
(for example: !@#$%,). If necessary, the passphrase for your hub will have to be changed.
d. Save the parameters.
e. If you have connected the camera with an Ethernet cable, disconnect the cable.
f. The camera will disconnect for approximately 40 seconds before resetting. The indicator light
stays on when the camera is connected to the Wi-Fi network. (Fig. 11)
g. Update the camera status to be able to view its image.
If the Wi-Fi connection fails, you must reconfigure the camera by pressing the RESET button for 5
seconds using a pointed tool. The indicator light flashes rapidly. When the indicator light remains lit
steady or performs a cycle of 3 rapid flashes followed by 1 long flash, you can restart Wi-Fi or Ethernet
configuration of the camera (Fig. 12)
CHOOSING THE LOCATION OF THE SURVEILLANCE CAMERA
You must not direct your surveillance camera towards public thoroughfares or neighbours:
the surveillance camera must not be used to film public thoroughfares or other locations
which are the property of others. It is your responsibility to check the camera's orientation
to ensure these situations do not occur.
W - -
all or ceiling Mounting
8
-f
i i ParaMeters
icon, then .
cannot accept
(f . 13)
ig
passphrases which include special characters
Copyright © 2015 Somfy SAS. All rights reserved.