To Clean Interior (As Needed) - Dri-Eaz Sahara E Manual Del Propietário

lImportant Safety Instructions: Always disconnect the
A
Turbo Dryer from its power source before performing
any maintenance or cleaning.
To
CLEAN INTERIOR (AS NEEDED):
To remove grill and blower wheel:
1. Use a Phillips #2 screwdriver to remove 2 screws.
2. Remove inlet grill.
3. Loosen the blower wheel shaft nut (3(8" socket driver).
Note the backstop for ensuring alignment when replac-
ing wheel.
Pull the blower wheel out of the unit.
To reassemble unit:
Follow the steps above in reverse order (starting with #9).
Note:
Before tightening shaft nut on wheel, ensure that bolt is aligned with flat
spot on shaft (see photo A).
07-01534 Copyright 2006 Dri-Eaz Products, Inc,
141
Kinderkamack Rd. Park Ridge, NJ
To remove control panel and motor:
Rotate the unit onto its side so that the controls are facing up.
5. Unscrew 2 screws securing cord guard (#2 Phillips screwdriver).
6. Remove cord guard.
4
7. Remove
8. Pull motor assembly out of the housing.
Air Marketing Group ELC
07656
Tel. 201-782-1782 Fax. 201-782-1783 Web www amgair
motor mount bolts with 3/8
-
nutdriver.
corn
Email: info@amgair com