Viewing The Display; Plug And Play Feature; Selecting The Video Signal-Source - Samsung LN-R1550P Instrucciones De Propierario

Viewing the Display

Plug and Play Feature

When the TV is initially powered on, several basic settings proceed automatically and subsequently.
The following settings are available.
1.
2.
3.
4.
5.
6.
7.
Language: Select your language.
Air/Cable: Select your local cable company TV system.
Auto Program: Selects between terrestrial antenna connection or your local cable company TV system.
Clock Set: Sets the current time for the TV clock.
If you want to reset this feature...
1.
2.
3. This will change or reset the settings.

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the type of signal source that is
connected to the TV (i.e. an antenna or a cable system).
1.
2.
3.
4.
Press the INFO button on the remote control to view current channel and the status of certain audio-video settings.
The on-screen displays disappear after about ten seconds.
Press the button once more or wait approximately 10 seconds and it disappears automatically.
Press the POWER button on the remote control.
The message "Start Plug & Play" is displayed with "OK" selected.
Select the appropriate language by pressing the
Press the ENTER button to confirm your choice.
The message "Check antenna input." is displayed with "OK" selected.
Press the ENTER button.
Please check that the antenna cable is connected correctly.
Press the or button to select "Air", "STD", "HRC", or "IRC", then press the ENTER
Press the ENTER button to select "Start".
The channel search will start and end automatically.
After all the available channels are stored, the "Clock Set" menu appears.
ENTER
Press the button at any time to interrupt the memorization process.
Press the ENTER button.
Press the or button to move to the "Hour", "Minute" or "am/pm".
Set the "Hour", "Minute" or "am/pm" by pressing the
Press the ENTER button to confirm your setting.
The message "Enjoy your watching." is displayed.
The TV automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
You can also set the hour and minute by pressing the number buttons on the remote control.
Press the MENU button to display the menu.
Press the or button to select "Setup", then press the ENTER
Press the or button to select "Plug & Play", then press the ENTER
Press the MENU button to display the menu.
Press the or button to select "Channel", then press the ENTER
Press the ENTER button to select "Air/Cable".
Press the or button to select the Video signal source, then press the ENTER
Press the EXIT button to exit.
STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system that exists in your particular area.
At this point, the signal source has been selected. Proceed to "Storing Channels Automatically".
English-7
or button.
or button.
button.
button.
button.
button.
button.