FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, (2)
This device must accept any interference received, including interference that may
cause undesired operation.
FCC Part 15 Class B-specific
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC exposure limit compliance statement (SAR statement)
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance.
Industry Canada Compliance
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
The device could automatically discontinue transmission in case of absence of
information to transmit, or operational failure. Note that this is not intended to
prohibit transmission of control or signaling information or the use of repetitive
codes where required by the technology.
•
The device for operation in the band 5150–5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel mobile
satellite systems;
•
The maximum antenna gain permitted for devices in the bands 5250–5350
MHz and 5470–5725 MHz shall comply with the e.i.r.p. limit; and
•
The maximum antenna gain permitted for devices in the band 5725–5825
MHz shall comply with the e.i.r.p. limits specified for point-to-point and non
point-to-point operation as appropriate.
In addition, high-power radars are allocated as primary users (i.e. priority users)
of the bands 5250–5350 MHz and 5650–5850 MHz and that these radars could
cause interference and/or damage to LE-LAN devices.
L'appareil pourrait automatiquement interrompre la transmission s'il n'y
a aucune information à transmettre ou en cas de panne fonctionnelle. À
noter que l'objectif de cette disposition n'est pas d'empêcher la transmission
d'informations de contrôle ou de signalisation, ou encore l'utilisation de codes
répétitifs exigés par la technique.
•
L'appareil fonctionnant dans la bande comprise entre 5 150 et 5 250 MHz est
uniquement réservé à une utilisation en intérieur, afin de réduire le risque
d'interférences nocives aux systèmes mobiles par satellite utilisant le même
canal ;
•
Le gain d'antenne maximum autorisé pour les appareils fonctionnant dans
les bandes comprises entre 5 250 et 5 350 MHz, et entre 5 470 et 5 725 MHz,
doit se conformer à la limite de p.i.r.e. ; et
•
Le gain d'antenne maximum autorisé pour les appareils fonctionnant dans
la bande comprise entre 5 725 et 5 825 MHz doit se conformer aux limites
de p.i.r.e. spécifiées pour l'exploitation point à point et non point à point,
selon le cas.
De plus, les utilisateurs de radars de haute puissance sont désignés comme
utilisateurs principaux (c.-à-d. comme utilisateurs prioritaires) des bandes
comprises entre 5 250 et 5 350 MHz, et entre 5 650 et 5 850 MHz, et ces radars
pourraient causer des interférences et/ou des dommages aux appareils LAN-EL.
CE RF Exposure Compliance
This device meets the EU requirements (1999/519/EC) and the International
Commission on Non-Ionizing Radiation Protection (ICNIRP) on the limitation
of exposure of the general public to electromagnetic fields by way of health
protection.
This device is restricted to indoor use only when operating in the 5150 to 5350
MHz frequency range.
v.15a