Using The Product As Intended; Contents; Safety Notes; Technical Informatio - marklin 60975 Manual De Instrucciones

Using the Product as Intended

The 60975/60976/60977 decoders are for converting
Märklin/Trix H0 locomotives to digital.
!
Not suitable for motors with field-wound coils. Locomotives
with these motors must be converted with the appropriate motor
retrofit kits, item numbers 60941, 60943, or 60944.
Contents as Delivered
1 decoder
1 circuit board with a 21-pin connector
1 Circuit board retainer
1 Screw
1 speaker small
1 speaker big
1 Adhesive pad
Installation instructions
Warranty card
Tools also needed for the installation procedure include: regular
and cross-point screwdrivers, tweezers, and soldering station
with a maximum soldering temperature of up to 30 watts /
300˚Celsius / 572˚Fahrenheit with a fine tip, soldering flux for
electronics (0.5 - 1 mm / 0.02" – 0.04" diameter), de-soldering
braid or a de-soldering pump.

Safety Notes

• WARNING! Sharp edges and points required for operation.
• Do wiring and assembly work only on a voltage-free or
grounded work mat. Failure to do this can lead to dangerous
static charge from your body and to damage to the compo-
nents.
26
• Operate the decoder only with the authorized voltage (see
technical data).
There is a danger of burning yourself when working with a
soldering station.
Technical Information
• Continuous current load at the motor output
• Current load at the light outputs
• Current load at AUX 1 - AUX 4
• Current load at AUX 3 - AUX4 (logical output)
• Current load AUX + light
• Current load for motor and AUX 5/6
• Maximum total load
• Maximum voltage
• Sound performance (at 4 Ω /8 Ω)
• Short circuit and overload protection at the outputs lights front
(LV), lights rear (LH), AUX 1 – AUX 4 and at the motor outputs.

Functions

The mSD SoundDecoder is a sound decoder with very extensive
setting and adaptation possibilities. Additional sound functions
are available. This decoder can be updated. An appropriate
control device is required for this (60213/60214/60215 Central
Station CS2 with software version 4.0 or higher, 60216/60226 CS3
and/or 60971 Programmer).
The settings and digital functions can only be used in digital
operation. However, the same possibilities are not available in
all protocols.
These instructions describe the installation and the possible set-
≤ 1.1 amps
≤ 250 milliamps
each ≤ 250 milliamps
—
≤ 300 milliamps
≤ 1.1 amps
≤ 1.6 amps
≤ 40 volts
2.75 watts / 1.6 watts