Bernzomatic BZ8250HT Manual De Instrucciones página 3

USING THE HOLSTER
IMPORTANT
Placing belt clip on correct side of waist will enable you to quickly, and naturally, release cylinder from holster in an
emergency. When the cylinder is in the holster, do not move about vigorously or hit the cylinder. When using a support
other than your belt, do not permit the cylinder to be pulled by "stretching" the hose.
LIGHTING AND OPERATION
DANGER

Tipping the gas cylinder more than 60 degrees from its upright position may cause torch to flare. The torch has a built-
in regulator that controls pressure and reduces the risk of pulsating or yellow flames when used other than upright. It is
recommended to start working with a disposable hand torch cylinder at room temperature and to keep torch upright as
much as possible.
1. Remove torch from holster tube.
2. Open regulator valve (1) fully by turning adjustment knob (2) counter clockwise until it stops. Do not force. Always fully open
valve when lighting to prevent damage to ignition system. Never look into the burner tube (5) or point in unsafe direction.
3. Point torch in a safe direction and pull ignition button (3). Repeat if necessary while adjusting the valve (2) slightly.
4. After the torch lights the flame may be adjusted.
5. To adjust flame, turn the adjustment knob (2) to the required setting.
6. After use, make sure the regulator valve (1) is closed by turning adjustment knob (2) fully clockwise until it stops.
Do not force.
TO ENGAGE LOCK
1. To engage flame lock feature, with ignition button (3) depressed, press the lock button (4) down. Do not force.
2. While holding lock button (4) down, release the ignition button (3).
TO DISENGAGE LOCK
1. To release flame lock, pull ignition button (3) until lock releases.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
1. Assemble the cylinder into holster (6) using diagram provided below.
2. Attach holster to belt using belt clip on reverse side of holster. Right
handed users, attach on your right side. Left-handed users, attach on your
left side.
3. Insert torch burn tip into metal tube on side of holster (7)
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
08/19/16