Connecting Camera To Pc; Only For Cooled Versions; Use Of Drainage Tube (Cooled Versions) - Optika Italy C-B Serie Manual De Instrucciones

7.7

Connecting camera to PC

1. Connect one terminal of the USB cable to the
camera connector and the other terminal to a
USB port on the computer. (Fig. 12)
• NOTE: USB3.0 cameras can be connected to a
USB2.0 port. The camera will operate normally,
with some limitations due to improper power sup-
ply to the camera.
• The SW in any case will warn that the USB3.0
camera works in 2.0 mode indicating next to the
camera name "(USB2.0)"

7.7.1 Only for cooled versions

Connect the supplied power adapter to the connec-
tor ① to power the camera cooling system. (Fig. 13)
7.8

Use of drainage tube (cooled versions)

• NOTE: Use the drainage tube only when strict-
ly necessary.
Cooled cameras sometimes create condensation in-
side the camera body during normal use.
This condensation may interfere with the correct for-
mation of the image on the sensor.
To remove any condensation, act as follows.
1. Disconnect all cables from the camera (power
supply and USB).
2. Using a flat screwdriver, unscrew the screw ① on
the left side of the camera. (Fig. 14)
3. Immediately screw the drainage tube ② into the
empty hole. (Fig. 15)
• If the camera is connected to a USB cable or
power supply during this operation, there is
a risk that the electrostatic charge will attract
dirt and dust that will settle on the sensor.
• Periodically empty the drainage tube repeating in
reverse order the operations described above.
USB2.0
①
①
Page 12
USB3.0
F ig. 12 F ig. 12
F ig. 13 F ig. 13
F ig. 14 F ig. 14
②
F ig. 15 F ig. 15