Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Glass Cooktop (Cont.)
Metal Marks and Scratches
1. Be careful not to slide pots and pans across your cooktop. It
will leave metal markings on the cooktop surface.
These marks are removable using the CERAMA BRYTE
Ceramic Cooktop Cleaner with the CERAMA BRYTE
Cleaning Pad for Ceramic Cooktops.
Damage from Sugary Spills and Melted Plastic
Special care should be taken when removing hot substances to avoid permanent damage of the glass surface.
Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your
cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when
removing hot substances.
Be sure to use a new, sharp razor scraper.
Do not use a dull or nicked blade.
1. Turn off all surface units. Remove hot pans.
2. Wearing an oven mitt:
a. Use a single-edge razor blade scraper to move the
spill to a cool area on the cooktop.
b. Remove the spill with paper towels.

Probe

The temperature probe may be cleaned with soap and
water or a soap-filled scouring pad. Cool the temperature
probe before cleaning. Scour stubborn spots with a
soap-filled scouring pad, rinse and dry.
To order additional temperature probes, see the
Accessories and Consumer Support sections at the end
of this manual.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the oven.
Do not leave the temperature probe inside the oven
during a self or steam clean cycle.
24
2. If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
®
®
This should be removed immediately before heating again
or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness that
would scratch the cooktop.
3. Any remaining spillover should be left until the surface of the
cooktop has cooled.
4. Don't use the surface units again until all of the residue has
been completely removed.
NOTE: If pitting or indentation in the glass surface has already
occurred, the cooktop glass will have to be replaced. In this
case, service will be necessary.
49-2000386 Rev. 0

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para Design CAFE CES700M

Este manual también es adecuado para:

Cafe ces750m

Tabla de contenido