dirna Bergstrom bycool FLAT Instrucciones De Montage página 36

FLAT
ES
EN
-Lead equipment power cable up to the vehicle´s battery, gluing plastic supports on rear cabin side and faste-
ning it with flanges. Once cabin has been folded, lead cable along lower cabin side, fastening it with clamps
and M4 screws and up to battery with flanges. It must follow the same passage as original cable (thoroughly
clean the area before gluing plastic supports). When connecting equipment to battery, it will carry out a test
of all its leds, CP will show on the display and it will then be turned off.
IMPORTANT: Due to the complex system of electronic control for the equipment, the
power outlet should be made directly to the vehicle battery, not any other point serving
other vehicle accessories, taking precaution not to reverse the polarity when connecting
(2). If the polarity is reversed it can cause irreparable damage to the electronic control
and is not covered by warranty.
IMPORTANT: Please consult User's Guide before starting.
Detailed instructions
on power wiring assembly
1
2
+
36
Wiring
supply
®
2
-