Customer Service - Tiiwee X4 Manual Del Usuario

Ocultar thumbs

página de 50

/ 50
Contenido
Tabla de contenido
Marcadores

Idiomas disponibles

Se ngs

The factory se ngs are "5s" and "Led On". The sensor will respect a 5-seconds

wai ng me between 2 signals and that the LED indicator light will always ﬂash

if a movement is detected. These are the most commonly used se ngs.

1. If both switches are set to the ON posi on, as shown in picture 1, the LED will

ﬂash each me a movement is detected. A er each signal, a wai ng me of 5

seconds is set as a standard to allow a person to pass the detector without

triggering a signal con nuously.

2. If the top switch is set to "Oﬀ", the detector will respect a 5-minute delay

before it will become ac ve again. This is a power saving mode. A doorbell-sound

sound se ng on the Alarm unit is not advised with this delay.

3. If the lower switch is set to "Oﬀ", the Led light will not ﬂash each me a

signal is detected. This se ng saves ba ery power.

4. If both switches are in the "Oﬀ" posi on, as shown in Figure 2, the PIR sensor

will respect a 5-minute interval between 2 diﬀerent signals, nor will the LED

window ﬂash.

Low-voltage Reminder Func on: The indicator light will be con nuously on

when the voltage of the PIR is lower than 2.4V unless its light has been switched

oﬀ by se ng the internal switches.

Detec on Range Characteris cs

Top View

Side View

Technical Features

Power: The PIR sensor is powered through 3 x AAA 1.5V alkaline ba eries or by

an external 5V/1A DC power supply connected through the micro-USB port. The

ba eries can stay inside the sensor while the external power supply is connected

and in use. They will work as a power backup in case of 220V power failure. The

power adaptor is not included with the product.