T'nB EBSPBK Instrucciones página 10

EN
DESCRIPTIONS
1 - Last song & volume up
2 - Multifunction button (MFB)
3 - Next song & volume down
Charging the battery with USB cable
• Step1: Insert USB charging cable into USB port of PC.
• Step2: Connect charging cable with the charging port of headset.
• When the red light is on, the headset is charging.
• When the red light is off, the headset is charged fully.
• It takes about 2 hours to charge the headset fully.
Warning:
• The battery is rechargeable.
• First time charging : Before you use this headset, please charge the
battery of headset fully
A ) How to enter pairing mode
Be sure BH-06 in power off status first. Press and hold the MFB for
8 seconds, till Red and blue Led blink alternately, or you hear the
indication "Pairing" . And then release the MFB. The unit will become
pairing mode.
B ) Pairing the headset with mobile phone
Please make sure your mobile phone has function that can be used.
Specific pairing procedures were not the same with different mobile
phone. Please refer to your mobile phone manual for further informa-
tion. Steps as follows:
1- Please keep the headset and mobile phone in the range of 1 meter
when pairing.
2- Start the function of mobile phone and search the devices.
3- Make the headset enter into pairing mode (Please refer to "how to
enter into pairing mode").
• After searched, select "BH-06"in the device list.
- According to indication, enter password or PIN No:"0000", and
- After successful pairing, select "BH-06" in the device list, and
- After successful connecting, the blue LED of the headset quickly
Notes: If the headset is in standby mode and does n't connect to any
devices, BH-06 will power off automatic 8 minutes later.
Notice-EBSPBK_2.indd 10
5
press the key of " Yes" or "confirmed".
press "connect".
blinks twice.
1
4
6
4 - LED Indicator
5 - Built-in microphone
6 - Charging port
10
2
3
17/04/2015 10:00