Cleaning/Servicing The Gas Grill; Safety Notice - Enders SAN DIEGO 3 Manual De Uso

SAN DIEGO 3

CLEANING/SERVICING THE GAS GRILL

SAFETY NOTICE

!
Despite careful processing of all individual
Q
parts, individual components can have sharp
edges. Therefore, please wear safety gloves,
to avoid getting cut.
Hot surface: Do not clean the gas grill until it
Q
has sufficiently cooled off.
RISK OF FIRE AND EXPLOSION
Avoiding grease fires:
Clean the appliance each time before use,
Q
to avoid the accumulation of grease. When
doing so, pay particular attention to grease
accumulation on the inside of the firebox,
the flame covers, the grease drip tray and
the grease cup.
Do not use any flammable cleaning agents.
Q
Handling the gas installation/gas grill:
Repairs and servicing of the gas-conveying
Q
parts can only be conducted by specialists
authorized to do so.
Dab away excess grease/marinade from the grill
Q
items before placing them on the grill. This does not
reduce the flavour of the grill items but solely serves
the purpose of preventing grease fires.
Clean the grill after each use.
Q
Do not use any abrasive or chloric cleaning agents.
Q
Pull out the grease drip tray and the grease cup and
Q
dispose of the grease in an environmentally sound
manner.
Wipe of the surfaces with a damp rag or rinse them
Q
off with hot water. If necessary, use a mild cleaning
agent. Rinse off with water and dry all surfaces with
a microfibre cleaning cloth.
When using a mild cleaning agent, you should also
Q
observe the manufacturer's instructions/product
information, to avoid damage to the surface.
Do not make any modifications to the gas
Q
grill or pressure regulator. The hose must
be serviced after 5 years (refer to the date of
manufacturer on the hose).
Replace the pressure regulator and the
Q
hose after 10 years at the latest; even if no
external damage can be detected. Make sure
that the pressure regulator is approved for
your country and the gas used and that it is
adjusted to the correct output pressure (refer
to Technical Specifications) . A new hose
cannot be longer than 1.5 m.
All components, which were sealed by the
Q
manufacturer or its representative, cannot
be manipulated or modified.
Together with oil, the gas forms an explosive
Q
mixture. Never try to loosen tight valves or
regulator knobs with oil or penetrating oil.
The burners can be removed for cleaning
Q
purposes.
Allow the appliance to thoroughly dry before using it
Q
again.
If, in exceptional cases, the burner tube is clogged,
Q
it must be cleared using a needle or a pipe cleaner.
11
8116630