Kohler Sterling 950C Serie Guia De Instalacion página 10

10. Adjust and Secure the Door
NOTE: The strike jamb and door panel can adjust 3/4" (1.9 cm). Do not adjust more than 3/4" (1.9 cm).
Adjust the door panel until both the hinge expander jamb and strike expander jamb are equally
spaced.
Open and close the door panel. Make sure the bottom seal does not hang on the bottom track.
Adjust if needed until the bottom seal is properly positioned.
Adjust the hinge expander jamb until there is 3/16" (5 mm) clearance between the wall jamb and
the strike expander jamb at the top and bottom of the door.
Tighten the screws.
11. Install the Catch
NOTE: The catch will be above the handle in left swinging configured doors. The catch will be below the
handle in right swinging configured doors.
Attach the catch to the inside of the door panel strike side frame using two #6-20 x 3/8" screws.
Adjust the catch until the door panel closes firmly against the strike jamb.
1034023-2-D
3/16" (5 mm)
Door Panel
Strike Side Frame
10
Strike Jamb
Catch
#6-20 x 3/8"
Panhead Screw
Sterling