Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Car Seat Adapter Installation:
1 Press gray release buttons on the side of the stroller and pull upward to remove the
accessory mounting bracket plugs
2 Insert Adapter Brackets into the lower accessory mounting slots on your stroller. The
Adapter Brackets are secure when they click into place.
NOTE: Left and right are determined by standing in front of and facing the stroller
and each Adapter Bracket is labeled with an L or an R for your convenience.
3 Connect the two L-shaped bars to complete the support bar.
4 Insert the support bar into the Adapter Brackets until it clicks into place.
5 Snap button position 1 is used for the Britax B-Safe 35.
Snap button position 2 is used for older Britax B-Safe car seats.
6 Place car seat on the car seat adapter brackets and press down firmly until it clicks
into place.
To remove car seat:
Follow the steps in your car seat' s instruction manual to remove car seat from
adapters.
To remove adapters:
7 Press gray release buttons on the side of the stroller and pull upward to remove.
WARNING:
FOLLOW ALL THE INSTRUCTIONS AND WARNINGS IN YOUR STROLLER'S
INSTRUCTION MANUAL.
• Keep these instructions for future reference.
• Read these instructions carefully before use. Your child' s safety may be affected if
you don't follow these instructions.
• NEVER leave child unattended.
• IMPORTANT! While the child is in the car seat, always use the restraint system
provided by the manufacturer.
• WARNING: Check that the car seat attachment devices are correctly engaged
before use.
• Accessories not approved by Baby Jogger® shall not be used.
• Only use replacement parts supplied or recommended by Baby Jogger®.
• Wipe clean using a damp cloth.
3
Publicidad
