Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
Disposal of Used Battery
A battery may contain hazardous substances that could be endangering to environment and
human health.
T
h
s i
y s
m
b
l o
m
a
k r
e
shall not be treated as municipal waste. Instead it shall be left at the appropriate
collection point for recycling.
B
y
e
n
s
r u
n i
g
h t
e
u
s
potential negative consequences for the environment and human health. The
recycling of materials will help to conserve natural resources.
For more information about collection and recycling of used battery, please contact your local
municipality, your waste disposal service or the point of sale where you purchased this point.
TROUBLESHOOTING
PROBLEM
Error E1 displayed on
control panel.
Error E2 displayed on
control panel.
Error E3 displayed on
control panel.
No power; logs do not
glow.
No flame effect but logs
are glowing.
Heater and blower
do not power on but
rest of functions are
working.
d
o
n
h t
e
b
t a
e t
y r
a
n
/ d
e
d
b
t a
e t
y r
s i
d
s i
p
o
s
e
POSSIBLE CAUSE CORRECTIVE ACTION
The overheat
sensor has been
engaged.
The thermostat
sensor is broken
or not working
correctly.
Heater override
function is engaged
The unit does not
have power.
The flame effect is
powered off.
Heater override
function is engaged
r o
p
a
k c
a
g
n i
g
n i
d
c i
a
e t
d
f o
c
r o
e r
t c
, y l
y
o
u
w
l l i
Unplug unit, wait 15-20 minutes, then the sensor will
reset itself. Plug the unit back in and turn on the
heater. If the problem persists, call customer service.
Note: The other functions will work normally excluding
the heater. Until the problem is solved, the error will
only appear/sound when the heater button is pressed.
Unplug unit, wait 15-20 minutes, then the sensor will
reset itself. Plug the unit back in and turn on the
heater. If the problem persists, call customer service.
Note: The other functions will work normally excluding
the heater. Until the problem is solved, the error will
only appear/sound when the heater button is pressed.
To unlock the heater, simply press and hold the
temperature button for 10 seconds (See page 8
Heater Override Section for more details).
Check that the power cord is securely plugged into a
standard 120V outlet. Then check to make sure the
unit is powered on.
Push the flame brightness button until desired level
is acheived.
To unlock the heater, simply press and hold the
temperature button for 10 seconds (See page 8
Heater Override Section for more details).
10
s
h t
t a
u
s
e
d
b
t a
e t
y r
h
e
p l
p
e r
v
e
t n
Publicidad
Tabla de contenido
