AKASO P30 WiFi Camera Manual De Usario página 6

4. Add Your Camera
Follow the on-screen instructions to finish the setup to connect your router, this camera
only supports 2.4GHz WIFI Network.
Way 1. Add device by QR Code - Use camera to scan the QR code on the mobile phone
which contains net-pairing information.
Note: When the device is powered on, the indicator light will be on. After the beep is
heard, the device indicator light flashes red quickly.
① Click "Add Device → Security Camera → next step → enter WiFi Password → confirm".
Gunnar
84.3°F High H...
Outdoor Temp Outdoor AQL Outdoor Humid...
All Devices Living Room Bedroom Setting
Nodevices yet
Add Device
Smart Scenes
My Home Profile
06
30cm ~ 100cm
Select Device Type
Zigbee Bluetooth All
Frequently Added
Security Camera
ZigBee Gateway
T&H Sensor
Wall Socket(ZigBee)
Wall Switch(ZigBee)
Curtain Switch
Add Device Otherwise
Power the device on and make
sure the indicator is flashing
quickly or a prompt tone is heard
How to set the indicator to flash
quickly or with a prompt tone
next step
② A QR code will be shown, just face the phone to the camera, a beep sounds, then click
"I HEARD THE BEEP", see below picture
Cancel
Scan QR code with the IP Cam
Point the code to the camera lens for 20cm.
NOTHING HAPPEND I HEARD THE BEEP
③ Wait the connecting for a while, the device will be added successfully in seconds. Click
Camera icon to preview camera live image.
Cancel
Enter your home's Wi-Fi pa...
Wi-Fi: AKASO_WiFi Change Network
Confirm
Only supported on 2.4GHz Wi-Fi networks
07