Precautions For Use - Blue Connect Guia De Inicio Rapido

B. Precautions for use
» Do not use Blue Connect for anything other than water analysis.
» Blue Connect is not a toy. Avoid shocks as they may damage it.
» Keep Blue Connect out of reach of children when handling it
(e.g. calibration and standby) due to the use of chemicals. Store
calibration products out of reach of children.
» Do not open the top part of the device (except when replacing
the battery). Follow carefully the battery replacement instructions.
Damage caused by liquids is not covered by the warranty.
» Do not open the bottom part of the device containing the probe
(except when replacing the probe). Follow carefully the probe
replacement instructions. Damage caused by liquids is not
covered by the warranty.
» Make sure not to leave the probe out of the water without the
storage cap filled with KCl (saturated potassium chloride), pH4 or,
as a last resort, running water with a good amount of cooking salt.
» Do not use demineralized water in the storage cap.
» Make sure the top part of the unit is out of the water to allow the
communication system to work.
» Do not leave Blue Connect in water with a temperature below 5°C
or above 50°C.
» Keep the Blue Connect serial number and key
» Store Blue Connect sheltered from frost.
[...] total amount of dissolved species in the pool, based on the assumption that
1
the main species is sodium chloride (NaCl or cooking salt). Sodium chloride
increases the conductivity of your pool water depending on its concentration.
An estimate of the sodium chloride level based on the conductivity will deviate
even more if other unknown salts are present in your pool. This deviation can
be checked using colorimetric detection strips specific for sodium chloride.
On the back of the quick start guide and on Blue Connect's storage cap.
2
2
Q U I C K S TA R T G U I D E
.
2