Pfister Clairmont 534 Serie Manual De Instrucciones página 2

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty • Philips head screwdriver • Pliers
• Adjustable wrench • Flashlight
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
A
D
P
P
C
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included:
A Faucet Body B Spray Head
D Quick Connector E Putty Plate
G Wing Nuts (2x) H Deck Metal Washer (2X) J Deck Rubber Washer
K Locknut M Weight
P Inlet Connectors (2x)
If any of these items are missing, please contact Price Pfister Consumer Services at
1-800-Pfaucet (1-800-732-8238).
• Cloth
N
H
B
F
J
H
E
K
M
G
C Pull-Out Hose
F Deckplate
N Mounting Ring
ENGLISH
5
These instructions cover two different
Option 1:
3 Hole With Deckplate
Installation
Go To
Step 6
3 HOLE INSTALLATION
6
6E
6A
BOTTOM GROOVE
6 THREE HOLE WITH DECKPLATE INSTALLATION
Place a bead of plumber's putty in the bottom groove along the outer edge of the Putty
Plate (6A). Place Metal Washer (6B) and Rubber Washer (6C) over center hole of sink
and into the center hole of Putty Plate (6A). Ensure that Plastic Putty Plate (6A) is
pressed on to Deckplate (6D). Install Deckplate (6D) over the three holes on the sink.
Retract Pullout Hose (6E) up through Faucet Body (6F), until the pullout hose fitting is
flush with the bottom of Mounting Shank (6G). Insert Faucet Supply Tubes (6H) and
Mounting Shank (6G) through the hole in Deckplate (6D). Be sure that Protective Caps
(6J) are in place.
Note: Do not feed the pullout Hose (6E) back down through the spout yet.
2
installations
Option 2:
1 Hole With Single Post
Installation
Go To
Step 8
6F
6J
6G
6H
6B
6D
6C
6A