Maintenance Schedule; Troubleshooting; Technical Data - Makita KR400MP Manual De Empleo Y De Seguridad

Maintenance schedule

Operating hour
Whole unit Visually inspect for
damaged parts
All fixing screws and nuts Tighten
Blades and protector Clean and visually inspect
for damaged parts
Gear case Supply grease
Drive axle Supply grease
Power unit Refer to the instruction manual of the power unit

Troubleshooting

Problem
The motor does not start.
The motor stops soon after its start.
The maximum speed is limited.
The blades do not rotate.
Stop the motor immediately!
The unit vibrates abnormally.
Stop the motor immediately!
The blades do not stop.
Stop the motor immediately!

Technical data

Model
Dimensions (L x W x H)
Mass
Cultivating width
Outer diameter of the blades
Gear ratio
Before Operation
Probable cause
Refer to the instruction manual of the power unit.
The blades are not installed properly.
Roots or the like are caught in the blades.
The drive system does not work properly.
The blades are not installed properly.
The drive system does not work properly.
The power unit does not work properly.
6
Daily
25 h 50 h
(10 h)
Install the blades properly.
Remove the foreign matter.
Ask Makita authorized service center to
inspect and repair it.
Install the blades properly.
Ask Makita authorized service center to
inspect and repair it.
Refer to the instruction manual of the power
unit.
inch (mm) 38" x 9-1/4" x 10-3/8" (965 x 235 x 264)
lbs (kg)
inch (mm)
inch (mm)
Corresponding page
5
5
5
5
5
Solution
KR400MP
6.5 (2.9)
6-5/16" (160)
9-1/8" (232)
1/35