SSP MHP132 Manual De Instrucciones página 5

This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to the
position (A side) for clockwise rotation or to the
position (B side) for counterclockwise rotation.
Selecting the action mode
1
013419
CAUTION:
Always slide the action mode changing lever all
•
the way to your desired mode position. If you
operate the tool with the lever positioned halfway
between the mode symbols, the tool may be
damaged.
This tool has an action mode changing lever. For
rotation with hammering, slide the action mode
changing lever to the right (
slide the action mode changing lever to the left (
symbol).
ASSEMBLY
Installing side grip (auxiliary handle)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the side
grip.
1
2
3
5 6
013414
Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
1. Action mode
changing lever
symbol). For rotation only,
1. Grip base
2. Teeth
3. Side grip
(auxiliary
handle)
4. Protrusion
4
5. Loosen
6. Tighten
Installing or removing drill bit
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the bit.
1
013415
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly. To remove the bit,
turn the chuck key counterclockwise in just one hole,
then loosen the chuck by hand.
After using the chuck key, be sure to return it to the
original position.
Depth gauge (optional accessory)
2
1
013416
The depth gauge is convenient for drilling holes of
uniform depth. Install the depth gauge by the following
sequence.
1. Turn the side grip counterclockwise to loosen the
hex bolt.
2. Insert the depth gauge and adjust the depth of
hole.
3. Turn the side grip clockwise so that the depth
gauge and the grip base are fixed on the tool
completely.
NOTE:
The depth gauge cannot be used at the position where
the depth gauge strikes against the tool body.
5
1. Drill chuck
2
2. Chuck key
1. Side grip
2. Depth gauge
3. Grip base
4. Hex bolt
3
4