Schumacher Electric INSTANT POWER IP-1875C Manual Del Dueño página 2

Appliance Type Estimated Wattage
Camcorders, VCRs
Electrical Tools
Electrical Coolers
The DC socket has a 30 amp automatic overload protection circuit
breaker. If overload occurs, reset the breaker by pushing the breaker
button located on the back of the IP-1875C.
110 Volt ac power source chart
(Inverter {Not Included} Is Necessary)
When using with an inverter, it can operate appliances normally
powered by 110V AC.
Appliance Type Estimated Wattage
Spot Lights,
Sump Pumps
Faxes, TVs,
Small Power Tools
Computers, Printers,
Medium Power Tools,
Blenders
When the IP-1875C is used with an inverter, it can operate appliances
normally power by 110V AC. Inverter not included; must be purchased
separately.
*NOTE: Estimated time is conservatively reported. Actual time may
vary. Times are based on the IP-1875C having a full charge. Requires
the use of an inverter that is not included. Designed for up to a 300
watt inverter.
using the air compressor
PRECAUTION – Read instructions of the product being inflated
before using the compressor. Avoid over inflation, do not exceed
the manufacturers recommended pressures. DO NOT leave the
compressor unattended during use.
Schumacher Electric Corporation warrants your unit to be free from defects in material and workmanship, excepting abuse or misuse, for a period of one year
from the date of sale to the original user or consumer purchaser. If your unit fails or malfunctions within the first 30 days of the warranty, we will replace it with a
new unit. If your unit malfunctions or fails within the 12 month warranty period because of a defect in material or workmanship, we will repair without charge.
The internal battery, excluding units with swollen batteries or melted battery terminals, carries a 90-day warranty from the date of purchase. Proof of purchase
required. All battery replacements will be at the sole discretion of the manufacturer or his designated agents.
This warranty is in lieu of all other express warranties. The duration of any implied warranty, including but not limited to any implied warranty of merchantability
or fitness for a particular purpose, made in respect to your unit is limited to the period of the express warranty set forth above.
For warranty service, return your product, with proof of purchase, to the factory or a designated agent: Schumacher Electric Corporation Warranty Service
Department, 1025 E. Thompson Street, PO Box 280, Hoopeston, IL 60942. Phone 1-800-621-5485, Customer Service hours: 7 AM to 4:30 PM CST.
You will be responsible for all insurance and freight or other transportation charges to the factory or point of repair. We will return your unit freight prepaid if
repair is covered under warranty. Your unit should be properly packed to avoid damage in transit, since we will not be responsible for any such damage.
In no event shall Schumacher Electric Corporation be liable for consequential or incidental damages. Some states do not allow limitations on the length of
the implied warranty or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This
warranty gives you specific legal rights and you may also have other rights which vary from state to state.
Call Customer Service if you have questions: 1-800-621-5485 (Hours: 7 a.m. – 4:30 p.m. CST)
Estimated Time*
15 Watts 12 Hours
24 Watts 7 Hours
48 Watts 3 Hours
Estimated Time*
100 Watts 1.5 Hours
150 Watts 1 Hour
200 Watts 45 Minutes
limited warranty
CONTAINS SEAlED lEAD-ACID BATTERY. MUST BE DISPOSED
OF PROPERlY.
WARNING: Possible explosion hazard. Contact with battery acid may
cause severe burns and blindness. Keep out of reach of children.
801 Business Center Drive, Mount Prospect, Il 60056-2179
Send Warranty Product Repairs to: Schumacher Electric Corporation
1025 East Thompson, Hoopeston, Il 60942-0280
The 12 volt compressor is rated for 280 PSI pressure. The hose is
stored in the back compartment of your IP-1875C. The ON / OFF
switch for the compressor is located on the back of the IP-1875C
below the charger plug.
1. There are three nozzles to inflate products. Use appropriate
nozzle.
2. To inflate a tire, unscrew the valve stem cap from the tire.
3. Attach the nozzle of the compressor hose and thread or latch
onto the product stem until it is secure.
4. To start the air compressor, push the switch located on the back
of the IP-1875C to ON.
5. Inflate product and when the product is inflated to the proper air
pressure, push the switch to OFF.
NOTE: The air compressor will run for a maximum of 15 minutes
or it may automatically shut down sooner if a high load causes it
to overheat. It will then cool for 10 minutes. After 10 minutes, the
air compressor will automatically restart.
Estimated time for inflating
Vehicle 13" to 16"
Bike tire
Balls
Use a gauge to ensure the proper pressure has been reached. Do
not over inflate.
The IP-1875C can be stored in any position. When the IP-1875C is ON,
the clamps are live and will produce arcing or sparking if they come
in contact with each other. To prevent accidental arcing, always keep
the clamps on the side ears and the JUMP START ON/OFF switch in
the OFF position when not using it to jump start a vehicle.
All batteries are affected by temperature. The ideal storage
temperature is at 70 degrees Fahrenheit. Performance varies based
on battery temperature conditions.
3 to 16 minutes
30 to 40 seconds
5 to 30 seconds
storage