Maintenance And Cleaning - Mestra R-100035 Manual De Instrucciones

English
The R-100035 Curing Light is used for fast effective curing of photo-polymerisable materials
commonly used in the dental field. Its frequency range is 350 - 400 nanometers. Please read thoroughly
the following instructions for correct use of this machine to obtain maximum output.
INSTALLATION
•
Carefully unpack the Curing Light. Check that it has not been damaged in transit.
•
Place the unit on a flat and firm surface well away from heat sources or vibrations.
•
In order to avoid damage during transport, the lamps (4 x 9 W) are supplied disconnected. To install
them, remove the tray and then place each lamp in its holder. Do this carefully to avoid possible
breakage.
•
Connect the machine to a 230 V, 50/60 Hz power supply with earth.
•
Activate the main switch at the back of the machine. The machine is ready for operation.
HOW TO USE THE CURING LIGHT
•
Remove the tray and place on it the parts to be cured (4 pieces maximum).
•
Place the tray back on the machine and select the time with the timer. Curing time goes from 0 to 15
minutes.
•
The lamps inside will light up. When the time selected ends, the timer will emit an acoustic signal.
•
Lamps emit UV radiation which may be harmful to eyesight. If you have to open the tray while the
machine is working, disconnect it first.
•
When the cycle finishes, remove the cured parts.

MAINTENANCE AND CLEANING

•
Curing Lights have a limited life span. We recommend changing the lamps between 500 (ideal) to
1,000 (maximum) working hours.
•
There is a fuse holder on the power cable base. Change the fuse (2 A) when required.
•
The machine should be cleaned periodically with a damp soapy cloth. Before cleaning the machine,
disconnect from the power supply.
PRECAUTIONS
♦ Before connecting the machine, make sure it has 230 V, 50/60 Hz with earth.
♦ When cleaning the machine, do not immerse it in any kind of liquid.
♦ Do not use the Curing Light when it is too damp or next to any inflammable product (alcohol or
solvents).
♦ Change the lamps carefully to avoid breakages.
♦ The Curing Light should only be used for curing Dental Materials.
4
GB