Bracket Mount (Sold Separately) - Axis P5544 Guia De Instalacion

Page 16
13. Install the ceiling tile, with the camera mounted, into the ceiling.
14. Place the trim ring over the ceiling bracket and snap it into place.
15. Remove the protective plastic film.
Trim ring

Bracket Mount (sold separately)

The product is intended for installation in the middle of a ceiling to fully utilize the 360°
panoramic view. Installing the product close to obstacles such as walls, pillars and poles
will limit the use of the product. Using a bracket mount could limit the use of the product.
1. Install the selected bracket according to the instructions supplied
with the bracket. If drilling is required, make sure to use drill bits,
screws, and plugs that are appropriate for the material.
2. Loosen the 4 camera base lid screws and remove the camera base
lid, see illustration on page 7.
3. Route the network cable and the multi-connector cable, if
applicable, through the holes in the mounting bracket.
4. Hook the camera to the safety wire on the bracket.
5. Connect the network cable and, if applicable, the multi-connector
cable to the network camera.
6. Install the Axis midspan, see Install the Midspan, on page 17.
7. Check that the indicator LEDs on the midspan indicate the correct
conditions. See the table on page 11 for further details.
8. Put the camera base lid back in its original position.
9. Slide the unit holders on the network camera into the slots on the bracket and rotate the
camera unit.
10. Secure the network camera to the mounting bracket by fastening the 3 screws (Torx T30).
AXIS P5544 Installation Guide
Safety
wire
Wall bracket (mounting
example, sold separately)
Torx T30
Screws
Slots for
unit holders