Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Parts List & Operating Instructions
1
Part
No.
Item
No.
No.
Req'd
538314
1
2
⁕
3
⁕
544346
4
Items marked with an asterisk (⁕) are contained in
Hardware Kit No. 549851
WARNINg: Failure to follow these warnings could cause a loss of load, damage to equipment, and / or
failure of equipment, which may result in personal injury or property damage:
•
If the operator cannot read English, operating instructions and safety precautions must be read
and discussed in the operator's native language.
•
Wear eye protection that meets the requirements of ANSI Z87.1 and OSHA standards.
•
Before each use, inspect the jack for leaks and damaged, loose, or missing parts. Immediately
replace cut, frayed, or damaged hoses.
•
Do not modify this transmission jack or use attachments unless supplied by OTC. If a modification
is needed, please contact OTC Technical Services.
•
This jack is designed to remove or install only automotive or truck transmissions. Using the jack
in a manner for which it is not designed may result in injury or damage to equipment.
•
The load must not exceed the maximum rated capacity of 2,200 lbs.
•
Stay out from underneath the load at all times.
•
Secure the load to the jack.
•
Use the jack on hard, level surfaces only.
•
Lower the load completely before moving the jack.
Assembly Instructions
1. Assemble the handle to the pump by aligning the holes in the handle with
the holes in the pump cap and piston. Slide a pin through each hole, and
secure each pin with a retaining ring on each end. See Figure 1.
2. For use with a Rockwell or Eaton
the transmission mounting plate (No. 538316) on top of the white mounting
plate (No. 538320) as shown in the parts list drawing. Insert bolts through
the three holes in the plates. Secure the bolts by attaching a washer and
nut to each bolt from underneath the plates.
⁕
2
Description
1
Cylinder Mounting Plate
2
Elbow Fitting
1
Hex Screw
(1-8 x 82.3 MM)
1
Swivel Hand Pump
(see Form No. 544717)
Safety Precautions
®
RoadRanger
Form No. 540403, Sheet 1 of 2, Back
4
⁕
3
⁕
1
2
Item
No.
1
2
544331
544345
3
544332
4
5
6
®
truck transmission: Place
⁕
5
4
3
Part
No.
No.
Req'd
Description
⁕
1
90° Elbow
1
Hydraulic Cylinder
(see Form No. 544718)
1
Hydraulic Hose
1
Protective Sleeve
⁕
1
Cable Tie
⁕
1
Retaining Ring
Figure 1
⁕
6
Publicidad
Tabla de contenido
