marposs E86N Manual De Instalacion Y Uso página 76

ENGLISH
Detailed description of transmitter programming data:
Transmission channel – tens:
the tens field flashes. Increase it cyclically from the value <0> to the value <6>.
Transmission channel – units: the units field flashes. Increase it cyclically from the value <0> to the value <9>.
CAUTION:
When you confirm the programming (P1), incorrect selection of channels 65-69 or 00 is considered invalid and the
interface display flashes up the channel on which the interface is set and the transmitter can only be reset in "recovery"
mode (see sec.10.3 "Programming the transmitter in Recovery mode" on page 77).
Identification code: the first digit shows "I". The third may be selected from values <A, B, C, D>.
CAUTION:
A transmitter is completely identified by the operating channel number and by the identification code (e.g.: 12B).
Since the identification code is programmable for the transmitter but it is an external logic (CNC) input for the interface,
we recommend that you only change this parameter on the transmitter if you are sure that it is the same as that of the
Interface; if it is not, the system will not work due to the lack of communication and the only way to reset it will be to
perform a transmitter programming procedure in "Recovery" mode (see sec. 10.3 "Programming the transmitter in
Recovery mode" on page 77).
Activation mode: the first digit shows "A". The third cyclically takes the values <0> for radio activation and <1> for
mechanical activation.
CAUTION:
Leave the default value shown on the previous page.
Operating time: the first digit shows "t". Set the third to a value between <0 and 8>, corresponding to an operating time
ranging from a minimum of 4" (value 0) to infinity (value 8).
Timer retriggering: the first digit shows "r". The third cyclically takes the values <0> for retrigger disabled and <1> for
retrigger enabled.
This data item allows you to reset the timer after each change in the probe status.
Confirm data programmed. The first digit shows "P". The third cyclically takes the values <0> for do not programme
the transmitter and <1> for programme it.
76 E86N- Touch system with radio transmission