Battery Replacement - Digi Sport Instruments DW-2026 Modo De Empleo

www.digisportinstruments.com
INSTRUCTION MANUAL
PEDOMETER DW2026
OPERATING INSTRUCTIONS:
Protective plastic film: Close
inspection of LCD readout will
reveal that there is a thin layer of
plastic that is covering the entire
screen. You may feel free to
remove this thin plastic film, but
only if you promise to not scratch
the readout.
Mounting Instructions: Attach the
pedometer securely to your waist
band or belt, as close as possible to
the centre of your right or left side.
Using your new pedometer:
Before you put the pedometer on ,
press the RESET button until the
LCD readout reads
The pedometer will register every
step you take. It is designed to
register up to and including 99,999
steps, which it is approximately 45
miles.
So as to extend the battery's life,
the LCD readout is designed to
shut off when it is not in use. To
view the readout, simply press the
RESET button once.
The MODE button: Leaving aside
what we have mentioned before,
the LCD readout displays the
number of steps . Press the button
once, and
equivalent number of miles. Press
this button twice, and you will see
the number of kilometres. And
finally, press the button once more
and you will see the number of
calories that you have burn while
you were walking this distance.
Pretty simple, isn't it?
The ADJUST button: For those
who are using this device to
determine the amount of calories
that have been burn, it is important
to input your approximate weight (
in kilograms) and stride into the
pedometer so you will know more
precisely how many calories you
have actually burned.
If you want to adjust the step-length
press once the ADJUST then use
RESET to adjust the weight and
then press adjust again and use the
RESET to adjust the step length.
00000.
1- Press the RESET button to get the
readout.
2- Make sure that the readout is
registering the steps (Take into
account that the steps that are
being registered are not labelled yet
in kilometers ,miles or calories).
3- In this step, you will need to
calculate your weight in kilometers.
Since 1 pound = 2.2 kilograms (kg),
divide your weight by 2.2
4- The result will be your weight in kg.
5- Press the ADJUST button, you will
notice that the number on the
screen has changed.
6- Press the RESET button repeatedly
until your approximate weight in
kilograms appears on the readout
screen .
you will get the
PROBLEM SOLUTIONS
Make sure
pedometer is properly
Not all your
attached to your waist.
steps are
registering
The battery is low, and it
must be replaced!
The LCD panel
does not work
The LCD panel The pedometer has
is dark and you been operated in high
are not able to temperatures for too
read the display long, or it has been put
under the direct sun light
for an extended period
of time.
The display will recover
when the temperature
normalizes.
don't worry!
during this time, the
pedometer will continue
registering
recording your steps.

BATTERY REPLACEMENT:

This Pedometer will operate for
many months without changing the
battery. However, if the battery
must be replaced, insert a penny or
dime in the slot on the button edge
of the pedometer, as it is shown in
the diagram .Then, turn the coin
until the top plastic cover pops off.
Use the point of a small knife to
push the battery out of its metal
enclosure, as it is shown in the
picture. Use an AG-13 Button type
replacement battery.
Replace the plastic cover
latching it into the procuring
supports at the top, and then, snap
the button of the plastic cover back
into place.
THE WARRANTY DOES
NOT COVER THE
BATTERY.
that the
However
Because
and
by