Troubleshooting; Installation - Progress PES6000E Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 58
To remove the dirt:
1. – Remove immediately: melted plas-
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to
the appliance. Use a special scraper
for the glass . Put the scraper on the
glass surface at an acute angle and
move the blade on the surface .
– Remove after the appliance is
sufficiently cool: limescale rings ,

TROUBLESHOOTING

Problem
You cannot activate the appli-
ance or operate it.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.

INSTALLATION

Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
2. Clean the appliance with a moist cloth
3. At the end rub the appliance dry
Possible cause
Problem with the house electri-
cal system.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
water rings, fat stains, shiny metallic
discolorations. Use a special cleaning
agent for glass ceramic or stainless
steel.
and some detergent.
with a clean cloth.
Activate the appliance again
and set the heat setting in less
than 10 seconds.
Examine the fuse in the electri-
cal system of the house in the
fuse box. If the fuses blow
again and again, speak to
qualified electrician.
progress 27
Remedy

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido