artograph LED 500 Guía De Configuración Rápida página 2

Important Safety Information
Please refer to pages 2 – 6 in the enclosed Owner's Manual for detailed safety information.
Step One – Review Package Contents (page 13)
1. LED 500 Digital Art Projector
™ ™
2. Remote control w/one CR2032/3V battery
3. Power supply (AC/DC adapter + power cord)
4. RGB computer cable
5. Composite cable
g
6. RGB VGA adapter for MAC
7. Multi-card USB card reader
8. Soft storage bag for LED 500
™
9. Owner's Manual (English)
10. CD Owner's Manual
Optional Extras discussed on page 14 of the Owner's
Manual are either available from Artograph or through
your local consumer electronics store.
Step Two – Getting Started (Page 19)
1. Remove protective film from projector
2. Install CR2032/3V battery into remote control
3. Review remote control features:
POWER: on/off
INPUT: input source
MUTE: mutes sounds
VOLUME + / VOLUME –: adjusts volume
PAGE / PAGE : next screen
AUTO: RGB-PC input image
BLANk: Screen on/off
: moves cursor
Ok
Ok: saves
EXIT: clears on-screen displays
O
: return to previous screen
SETTINGS: select or close menu
Q.MENU: quick access menu
STILL: freezes (not USB mode)
GRID: select one of 19 grid patterns + grid color
USB: access USB mode
MARk: set optional functions
kEY.S p / kEY.S q: Adjusts keystone
tt uu: controls playback of My Media
: shows 3D images
II
: switch left to right in 3D mode
Color buttons: access special functions
Note: when using remote control, the optimal range is less than 3 meters and within
a 30 degree arc of the IR receiver. The IR receiver is on the back of the receiver.
8
1
9
6
3
7
5
2
10
Step Three – Start Projector
1. Mount LED 500 onto a tri-pod or sturdy,
™
hard platform near a power outlet
(DO NOT block vents on projector)
2. Connect power supply cord into nearby
outlet and into the back of LED 500
marked DC IN
3. Aim LED 500 toward desired surface
™
4
4. Press red Power button on remote
or lighted button on top
of LED 500
™
5. FOCUS – Rotate focus wheel on side
of LED 500
™
Step Four – Select Input Source
The LED 500 accepts input from a variety of devices including computers, SD cards,
™
HDMI devices and USB flashdrives:
1. USB (Pages 25-26) insert USB flashdrive into USB port
a. "New external input is connected;
do you want to use this?" Answer YES
b. If USB device is not recognized:
i. press "USB" button on remote (or)
ii. press "input" button on remote and
manually select USB
2. SD Card Reader (Same as USB Pages 25 – 26)
Insert SD memory card into multi-card reader; insert multi-card
reader into USB port
a. All Media (Page 25): allows viewing all media files at once
b. Movie List (Pages 28-33): allows viewing all movie files
c. Photo List (Pages 34-36): allows viewing of all photo files
d. Music List (Pages 29, 36-37, 49): allows viewing of all music files
e. Files List (Pages 38-39): allows viewing of MicroSoft
3. RGB/HDMI Devices (Page 54)
Direct connect LED 500
a. PC: use RGB cable or HDMI cable
b. MAC: use MAC Adapter cable or HDMI cable
(Page 21)
™
Focus Wheel
(Page 23)
Ports for RGB/HDMI Devices
; the following menus will appear:
Office document files
®
to PC or MAC computer
™
LED 500™
Tripod Mobile
Floor Stand
USB Port