Filling The Fuel Tank; Checking The Engine-Oil Level; Adjusting The Handle Height - Toro Super Recycler 20381 Manual Del Operador

Filling the Fuel Tank

•
For best results, use only clean, fresh, unleaded gasoline
with an octane rating of 87 or higher ((R+M)/2 rating
method).
•
Oxygenated fuel with up to 10% ethanol or 15% MTBE
by volume is acceptable.
•
Do not use ethanol blends of gasoline, such as E15
or E85, with more than 10% ethanol by volume.
Performance problems and/or engine damage may result,
which may not be covered under warranty.
•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or in fuel
containers over the winter unless fuel stabilizer has been
added to the fuel.
•
Do not add oil to gasoline.
Fill the fuel tank with fresh unleaded regular gasoline from a
major name-brand service station
Important: To reduce starting problems, add fuel
stabilizer to the fuel all season, mixing it with gasoline
less than 30 days old.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Remove the dipstick
(Figure 12).
Figure 12
(Figure 13).
1. Full
2. High
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
5. Read the oil level on the dipstick
•
If the oil is below the Add mark on the dipstick,
slowly pour a small amount of oil into the oil-fill
tube, wait 3 minutes, and then repeat steps 3
through 5 until the oil level is at the Full mark on
the dipstick
•
If the oil is above the Full mark on the dipstick,
drain the excess oil until the oil level is at the Full
mark on the dipstick. To drain the excess oil, refer
to Changing the Engine Oil (page
g186584
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
6. Install the dipstick into the oil-fill tube securely.

Adjusting the Handle Height

You may raise or lower the handle to a position comfortable
for you.
Rotate the handle lock, move the handle to 1 of 3 positions,
and lock the handle into position
9
Figure 13
3. Low
(Figure 13).
19).
(Figure 14).
g186624