INSTALL THE HOOD
Note: Remove the plastic protective
film from all exterior surfaces,
decorative flues and filters, prior to
final insallation.
DUCTED and NON-DUCTED
INSTALLATION
1. Open the front glass panel and
remove shipping tape from both air
cylinders.
2. Pull each cylinder to extend its lenght.
Fig.7
3. Align end of cylinder with mounting
bracket and push in to engange. Fig.8
4. Install hood onto (2) wall mounting
brackets. Make sure hood is level with
floor. Fig.9
C l i c k !
5. Lift glass front panel and remove
grease filter.Fig 10.
FIG.
8
- 9 -
FIG. 7
FIG. 9
FIG.1
0